Share Email Opening Apply Now Title Metrology Technician - Pressure  About the Organization Bionetics is a government services contractor specializing in engineering and life sciences with locations nationwide.   EOE Statement We are an equal employment opportunity employer. All qualified applicants will receive consideration for employment without regard to race, color, religion, gender, national origin, disability status, protected veteran status or any other characteristic protected by law.   Category Metrology   Description POSITION TITLE: Metrology Technician (Pressure) LOCATION: AFPSL, Heath, OH POSITION CLASSIFICATION: FLS Non-Exempt SUPERVISOR: Physical/Mechanical Department Manager HOURS: Per CBA (some overtime may be required) SALARY: $36.06/hour and fringe benefits (as per CBA) JOB DESCRIPTION: This Technician is responsible for providing calibration and repair services on Pressure equipment in the Physical/Mechanical Laboratory. Applies advanced technical knowledge to solve complex problems that typically cannot be solved solely by referencing manufacturer’s manuals or similar documents. Requires the ability to use complex test instruments and control equipment. RESPONSIBILITIES AND DUTIES: Essential/Typical Duties: Maintains, repairs, and calibrates Pressure Test, Measurement and Diagnostic Equipment (TMDE). Performs general maintenance and overhaul procedures; uses TMDE to troubleshoot and repair equipment. Non-Essential Duties: Performs other related duties as assigned. PHYSICAL REQUIREMENTS: Often – Climbing, Stooping, Kneeling, Reaching, Standing, Sitting, Walking, Pushing, Pulling, Talking, Hearing Lifting/Moving Requirements: The individual ability to lift up to 50 pounds. The ability to perform repetitive hand and arm movements when calibrating certain TMDE. ENVIRONMENTAL CONDITIONS: Normally works in an environmentally controlled work area.   Position Requirements REQUIREMENTS, EXPERIENCE AND EDUCATION: Associates Degree, or related equivalent experience desired. Minimum of three (3) years’ experience in metrology and repair of TMDE desired. Working knowledge of calibration and maintenance of DC/Low Frequency primary measurements standards is a plus. Ability to read and understand schematic and wiring drawings. Familiar with the requirements of ISO/IEC 17025 and USAF T.O. 00-20-14 is a plus. Must be a U.S. Citizen. Must be able to qualify for or have successfully completed a National Agency Check Investigation within the last ten (10) years. Above average proficiency with Microsoft Office (Outlook, Excel, Word), Windows based operating systems, and general internet navigation and usage required.   EQUAL OPPORTUNITY EMPLOYER: Minority/Female/Disability/Veteran VEVRAA Federal Contractor Employability in the U.S. only Pre-employment drug screen required   Full-Time/Part-Time Full-Time   Position Metrology Technician - Pressure   Number of Openings 1   Exempt/Non-Exempt Non-Exempt   Location AFPSL   This position is currently accepting applications. Apply Now WE ALSO RECOMMEND Other Jobs Within Same Category Metrology Technician-Optics in Heath, OH Posted on: 8/10/2022 [Apply Now] FAA Mobile Calibration Technician in Dallas, Texas Posted on: 8/9/2022 [Apply Now] Metrology Technician - Mass in Heath, OH Posted on: 4/26/2022 [Apply Now] Metrology Technician - Gage Blocks in Heath, OH Posted on: 4/26/2022 [Apply Now] Other Jobs Within 60 Miles Assistant Assembly Technician in Health, OH Posted on: 2/24/2023 [Apply Now] Electrical Engineer in Heath, OH Posted on: 6/15/2022 [Apply Now] Photonics/Nucleonics Engineer in Heath, OH Posted on: 6/15/2022 [Apply Now] Metrology Technician - Quality Assurance in Heath, OH Posted on: 8/10/2022 [Apply Now] Technical Writer (Engineering) in Health, OH Posted on: 11/22/2021 [Apply Now]

Click here for technical assistance.